Special Instructions for joining additional awnings

Note: Lay assembled awnings on a smooth flat surface for joining operation.

Tap awning joiner half way into front and back channel of existing fitted Awning.
Slide away from front and back channel for new additional awning, leaving exposed 3/4 of the panel to be joined.
Lower Awning into backchannels, slide new awning panels to meet existing awning panel. Snap lock together. Note: If extending to the right side of existing awning, slide extending panel over fitted panel. If extending to the left side of existing awning, slide extending panel under fitted panel.
Tap new front and back channels tight up to existing fitted awning channels.
Cut off excess front and back channels if necessary. Note: leave 10mm excess to allow for fitment of end caps. Fit end caps and fit to backchannel as per instructions. Adjust and lock awning to required position.